6
Press the Menu Select button directly below Exit
to return to Home screen.
Deleting a Channel in the Dynamic Zone
The radio must be in Dynamic Zone in order to
perform this operation.
1
or to ZnPr then press the Menu Select button
directly below ZnPr to enter Program Zone
screen.
The display shows the dynamic channels list.
2 or to the saved dynamic channel then press
the Menu Select button directly below Del.
The display shows Channel deleted screen.
3
Press the Menu Select button below Exit to
return to Home screen.
The Home screen shows <Dynamic Zone
Channels>.
If the channel deleted is the Home channel, the
Home screen shows <Zone Name>+”Blank”.
Multiple Control Head Features
This feature allows your transceiver to control a
combination of up to four O2 and O7 control heads on
APX Mobile (depending on the model). You can use
the CAN cables to connect in any configuration that
does not exceed 131 feet (40 meters) in combined
length. Refer the O2 or O7 Control Head Installation
Manual (6878215A01) for further information.
The Multiple Control Head (MCH) feature consists of
2 modes that can be programmed via Customer
Programming Software (CPS):
• All Active mode
• One Active mode
Note:
If two or more control heads are connected to
the system before enabling the MCH feature in
the CPS, the radio displays Extra CH or CH
ID # ERR. Both errors are FATAL.
Setting the ID of the Initial Control Head
This feature allows you to setup the control head in
the Front Panel Programming (FPP) mode. During
the setup, the control heads are defined as Control
67
English
To Next Page
Loading...
Need help?
General
