Using the Hang Up Box (HUB)
To temporarily suspend Scan Mode operation,
remove the control head from the Hang Up Box
(HUB).
You are allowed to use the control head while
scan is suspended. However, Priority Member
scanning is not suspended. This feature applies to
all Scan Lists and Scan Types. Scan is resumed
once the control head is returned to the holding
clip and the preprogrammed hang time has
elapsed.
Note:
Priority Scan List members are
continuously scanned only when the Scan
List, Designated Tx Member field is set to
“Talkback” in the radio programming.
Otherwise, all scan mode operation is
suspended.
Call Alert Paging
This feature allows your radio to work like a pager.
Even if other users are away from their radios, or if
they are unable to hear their radios, you can send
them an individual Call Alert page. You can also
verify if a radio is active on the system.
Depending on how your radio is programmed, when
you make an Enhanced Private Call, the radio either
automatically sends a call alert page if there is no
answer after the maximum ring time, or when you
press the PTT button.
Note:
This feature must be preprogrammed by a
qualified radio technician.
Receiving a Call Alert Page
When you receive a Call Alert page, you hear four
repeating alert tones and the LED blinks green. If Call
Alert Tone Auto Reset is enabled, you hear one alert
tone and the LED blinks green. The call received
icons blinks and the display shows Page received.
Press the PTT button to answer or press any
button to clear the Call Alert page.
See Making a Talkgroup Call on page 56 or Making a
Private Call (Trunking Only) on page 57 for more
information on returning the call.
80
English
To Next Page
Loading...
Need help?
General
