directly below OK to return to the main screen of
Contacts.
•
Sending a call alert page via the radio menu Call:
a)
or to Call.
b) Press the Menu Select button directly below
Call.
c) or to select the alias or ID, and press the
PTT button to initiate the call.
If the target radio does not respond after a
preprogrammed period of time, the display
shows Send page?.
d) To send the call alert page, press the Menu
Select button directly below Yes. To exit the
screen without sending the call alert page,
press the Menu Select button directly below
No.
The display shows Paging...<Alias>.
If the call alert page is sent successfully, you
hear four high-pitched tones and the display
shows Ack received. The radio returns to the
Home screen.
If the call alert page is not acknowledged, you
hear a low tone and the display shows No
acknowledge. Press the Menu Select button
directly below
OK to return to the main screen of
Contacts.
Enabling and Disabling In-Call User Alert
Make sure you are in Home mode where the default
zone and mode are being displayed.
You can enable and disable voice transmission, if
needed.
1
or to scroll to the VMut and press the Menu
Select button directly below VMut.
Voice mute is activated.
2 To turn the feature off, press the Menu Select
button directly below VMut or the VMut
preprogrammed button again.
Pressing the Menu Select button directly below
VMut or the VMut programmed button momentarily
toggles between Voice mute on and Voice mute
off. Voice mute on shown on the display
indicates that the radio is muted to all conventional
dispatch calls and affiliated trunking group calls.
82
English
To Next Page
Loading...
Need help?
General
