NAiS FP0-C32T User Manual

Self-Diagnostic and Troubleshooting
FP0
10 - 5
Matsushita Automation Controls
10.2 Troubleshooting
10.2 Troubleshooting
10.2.1 ERROR/ALARM LED is Blinking
OP- 110
FUNCTION ERR E45
The self-diagnostic error occurs.
<Condition>
Using NPST-GR software
In the ONLINE mode, select “STATUS DISPLAY.” At the bottom of the
“STATUS DISPLAY” window, you can find the error code.
Using FP programmer
II
Press the keys on the FP programmer
II
as shown on the right.
When self-diagnostic error occurs, the
screen shown on the right is displayed.
READ
1 ENTACLR
OP
(-)
SLF DIAGN ERR CD ( )
Error code Content of error
1 0
Check the error code using the programming tool.
<Procedure 1 >
Using FPSOFT
In the ONLINE mode, select “Monitor” from the menu bar of FPSOFT. And then
select “Status Display”. At the “PLC Error Flag” field, self-diagnostic error code
is displayed.
[ ]
Error code is 1 to 9
There is a syntax error in the program.
<Condition>
Execute a total-check function to determine the location of the syntax error.
Change to PROG. mode and clear the error.
Refer to your software manual, for details about the total-check method.
<Procedure 1 >
<Procedure 2>
.
next page

NAiS FP0-C32T Specifications

General

Brand	NAiS
Model	FP0-C32T
Category	Controller
Language	English