InstallationFP0
6-3Matsushita Automation Controls
6.1 Adding Expansion Units
6.1 Adding Expansion Units
Expansion method
1. Peel the seal on the side of the unit so that the internal
connector is exposed.
Seal
.
Notes
D
When peeling the seal on the side of the initial lot products,
the shaded part is exposed. Cut off the shaded part with a pair
of nippers or similar tool so that the internal connector is
exposed.
Cut here.
Shaded part
D
When removing the shaded part, use a sharp cutting object,
making sure that the shaded part is removed leaving a
smooth surface. Note that failure to remove the shaded part
completely can result in damage to the connector.
.
next page
To Next Page
Loading...
Need help?
General
