Native Instruments MASCHINE MK3 User Manual

5. Press PERFORM to enable Perform mode.
6. Slide a finger on the Smart Strip to control the parameter the Smart Strip is mapped to.
→ The effect will sound for the length of time your finger is held on the Smart Strip.
5.7.4 Notes Mode
In Notes mode, sliding your finger on the Smart Strip plays the pads you hold one after the oth-
er. Sliding your finger on the Smart Strip while no pad is held will play all Sounds mapped to
the pad matrix in Pad Mode or Keyboard mode. If you slide your finger from left to right, the
pads will be played in an ascending manner. If you slide your finger from right to left, the pads
will be played in a descending manner. This applies regardless of which pads (if any) are held.
To play notes using the Smart Strip:
1. Load a Group (in Pad mode) or Sound (in Keyboard/Chords mode) so they are mapped to
the pads.
2. Press the NOTES button to enable Notes mode.
3. Press and hold the pads you want to play.
4. Slide your finger on the Smart Strip to “strum” the sounds mapped to the pads.
Playing on the Controller
Using the Smart Strip
MASCHINE - Manual - 276

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs