Configure Switching
146
Insight Managed 28-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP 1G & 2 SFP+ 10G Fiber Ports
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 13.
The login window opens.
4. Enter the switch’s password in the password field.
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
The System Information page displays.
5. Select Switching > STP > Advanced > MST Port Configuration.
The Status section and MST Port Configuration section display.
Note: If no MST instances are configured on the switch, the page displays a
“No MSTs Available” message.
6. From the Select MST menu, select the MST for which you want to configure the port
settings.
7. To display information for all ports and LAGs, click the All link.
8. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the heading
row.
9. Configure the MST values for the selected interfaces:
• Port Priority. The priority for a particular port within the selected MST instance. The
port priority is set in multiples of 16. If you specify a value that is not a multiple of 16,
the priority is set to the priority is automatically set to the next lowest priority that is a
multiple of 16. For example, if you set a value between 0 and 15, the priority is set to
0. If you specify a number between 16 and 31, the priority is set to 16. Specify a value
in the range of 0–240. By default, the value is 128.
• Port Path Cost. Set the path cost to a new value for the specified port in the selected
MST instance. Specify a value in the range of 0–200000000. By default, the value
is 0.
10. Click the Apply button.
Your settings are saved.
11. To refresh the page with the latest information about the switch, click the Refresh button.
To Next Page
Loading...
Need help?
General
