Configuring Routing
188
Insight Managed 28-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP 1G & 2 SFP+ 10G Fiber Ports
Configure IPv6 Routing
Note: IPv6 is supported on VLAN interfaces only, not on physical ports.
Configure the IPv6 Global Routing Settings
You can configure IPv6 the global routing settings for the switch (as opposed to the IPv6
settings for an interface).
 To configure the IPv6 global routing settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 13.
The login window opens.
4. Enter the switch’s password in the password field.
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
The System Information page displays.
IcmpOutParmProbs The number of ICMP Parameter Problem messages sent.
IcmpOutSrcQuenchs The number of ICMP Source Quench messages sent.
IcmpOutRedirects The number of ICMP Redirect messages sent. Because hosts do not send
redirects, this counter is always zero for a host.
IcmpOutEchos The number of ICMP Echo (request) messages sent.
IcmpOutEchoReps The number of ICMP Echo Reply messages sent.
IcmpOutTimestamps The number of ICMP Timestamp (request) messages.
IcmpOutTimestampReps The number of ICMP Timestamp Reply messages sent.
IcmpOutAddrMasks The number of ICMP Address Mask Request messages sent.
Table 50. IP routing statistics information (continued)
Field Description
To Next Page
Loading...
Need help?
General
