186
GS748T Smart Switch
To create an Access Profile:
1. In the Acc
ess Profile Name field, specify the name of the access profile to be added.
The maximum length is 15 characters.
2. T
o activate an access profile, select the Activate Profile check box. You cannot add rules to
an active profile.
3. T
o deactivate an access profile, select the Deactivate Profile check box.
4. T
o remove an access profile, select the Remove Profile check box. The access profile
should be deactivated before removing the access profile.
5. Click Cancel
to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6. If
you make changes to the page, click Apply to apply the changes to the system.
The Profile Summary table shows the rules that are configured
for the profile, as the following
table describes.
Field Description
Rule Type Identifies the action the rule takes, which is either Permit or Deny.
Service Type Displays the type of service to allow or prohibit from accessing the switch
mana
gement interface:
•SNMP
•HTTP
•HTTPS
Source IP Address Displays the IP Address of the client
that may or may not originate
management traffic.
Mask Displays the subnet mask associated with the IP address.
Priority Displays the priority of the rule. The rules are validated against the incoming
mana
gement request in the ascending order of their priorities. If a rule
matches, action is performed and subsequent rules below are ignored.
Click Refresh to update the page with the most current information.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
