NETGEAR GS748T User Manual

71
GS748T Smart Switch
Neighbors Information
Use the LLDP Neighbors Information page to view the data that a specified interface has
received from other LLDP-enabled systems.
To display the LLDP Neighbors Information page, click System >
LLDP > Advanced >
Neighbors Information.
The following table describes the information that displays for all LLDP neighbors that have
been discovered.
Field Description
MSAP Entry Displays the Media Service Access Point (MSAP) entry number for the
rem
ote device.
Local Port Displays the interface on the local system th
at received LLDP information
from a remote system.
Chassis ID Subtype Identifies the type of data displayed in the Chassis ID field on the remote
system.
Chassis ID Identifies the remote 802 LAN device's chassis.
Port ID Subtype Identifies the type of data displayed
in the remote system’s Port ID field.
Port ID Identifies the physical address of the po
rt on the remote system from which
the data was sent.
System Name Identifies the system name associated with the remote dev
ice. If the field is
blank, the name might not be configured on the remote system.
Click Refresh to update the information on the screen with the most current data.

NETGEAR GS748T Specifications

General

Basic switching RJ-45 Ethernet ports quantity	48
MAC address table	16000 entries
Packet buffer memory	1.632 MB
Maximum data transfer rate	1 Gbit/s
Latency	20 µs
I/O ports	48 RJ-45 connectors for 10BASE-T, 100BASE-TX, and 1000BASE-T (Auto Uplink on all ports) 4 SFP slots for fiber Gigabit Ethernet modules
Dimensions (WxDxH)	440 x 260 x 43 mm
Power requirements	100-240VAC 50/60 Hz
Networking features	10BASE-T, 100BASE-TX, 1000BASE-T
Connectivity technology	Wired
Full duplex	Yes
Networking standards	IEEE 802.3x
Minimum system requirements	Category 5 network cables Network card for each PC Network software (e.g., Windows)
Mean time between failures (MTBF)	69930 h
Safety	UL listed (UL 1950)/cUL, IEC950/EN60950
LED indicators	Link, Power
Power consumption (typical)	70 W
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	4000 g