NETGEAR GS748T User Manual

271
GS748T Smart Switch
Quality of Service
Feature Sets Supported Default
Number of queues 8 N/A
Port based N/A N/A
802.1p 1 Enabled
DSCP 1 Disabled
Rate limiting All ports Disabled
Auto-QoS All ports Disabled
Security
Feature Sets Supported Default
802.1X All ports Disabled
MAC ACL 100 (Shared with IPv4/IPv6 ACLs) All MAC packets allowed
IPv4 access list 100 (shared with MAC ACL, IPv6
ACL)
All IP packets allowed
IPv6 access list 100 (shared with MAC ACL, IPv6
ACLs)
All IPv6 packets allowed
Password control access 1 Idle timeout = 5 mins.
Password = “password”
Management security 1 profile with 20 rules for
HTTP/HTTPS
/SNMP access to
allow/deny an IP address/subnet
All IP addresses allowed
Port MAC lock down All ports Disabled

NETGEAR GS748T Specifications

General

Basic switching RJ-45 Ethernet ports quantity	48
MAC address table	16000 entries
Packet buffer memory	1.632 MB
Maximum data transfer rate	1 Gbit/s
Latency	20 µs
I/O ports	48 RJ-45 connectors for 10BASE-T, 100BASE-TX, and 1000BASE-T (Auto Uplink on all ports) 4 SFP slots for fiber Gigabit Ethernet modules
Dimensions (WxDxH)	440 x 260 x 43 mm
Power requirements	100-240VAC 50/60 Hz
Networking features	10BASE-T, 100BASE-TX, 1000BASE-T
Connectivity technology	Wired
Full duplex	Yes
Networking standards	IEEE 802.3x
Minimum system requirements	Category 5 network cables Network card for each PC Network software (e.g., Windows)
Mean time between failures (MTBF)	69930 h
Safety	UL listed (UL 1950)/cUL, IEC950/EN60950
LED indicators	Link, Power
Power consumption (typical)	70 W
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	4000 g