EasyManuals Logo
Home>NETGEAR>Switch>GS748T

NETGEAR GS748T User Manual

NETGEAR GS748T
302 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
91
GS748T Smart Switch
Voice VLAN Properties
To display the Voice VLAN Properties page, click Switching Voice VLAN Basic
Properties.
To configure Voice VLAN:
1. Fro
m the Voice VLAN Status field, enable or disable Voice VLAN on the switch. If the
switch does not handle traffic from IP phones, the status should be disabled.
2. From the V
oice VLAN ID field, select the VLAN to use for voice traffic on the switch. The
VLAN must already exist on the switch. For information about how to create VLANs, see
VLAN Configuration on p
age 86.
3. From the Class of Servi
ce field, set the CoS tag value to be reassigned for packets
received on the Voice VLAN when Remark CoS is enabled.
4. From the Remark CoS
field, select Enable or Disable to reassign the CoS tag value to
packets received on the Voice VLAN.
5. From the V
oice VLAN Aging Time field, specify the amount of time after the last IP phone’s
OUI is aged out for a specific port. The port will age out after the bridge and voice aging
time.
6. Click Canc
el to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. If you make any change
s to this page, click Apply to send the updated configuration to the
switch.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS748T and is the answer not in the manual?

NETGEAR GS748T Specifications

General IconGeneral
Basic switching RJ-45 Ethernet ports quantity48
MAC address table16000 entries
Packet buffer memory1.632 MB
Maximum data transfer rate1 Gbit/s
Latency20 µs
I/O ports48 RJ-45 connectors for 10BASE-T, 100BASE-TX, and 1000BASE-T (Auto Uplink on all ports) 4 SFP slots for fiber Gigabit Ethernet modules
Dimensions (WxDxH)440 x 260 x 43 mm
Power requirements100-240VAC 50/60 Hz
Networking features10BASE-T, 100BASE-TX, 1000BASE-T
Connectivity technologyWired
Full duplexYes
Networking standardsIEEE 802.3x
Minimum system requirementsCategory 5 network cables Network card for each PC Network software (e.g., Windows)
Mean time between failures (MTBF)69930 h
SafetyUL listed (UL 1950)/cUL, IEC950/EN60950
LED indicatorsLink, Power
Power consumption (typical)70 W
Storage temperature (T-T)-10 - 70 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Weight4000 g

Related product manuals