NETGEAR GS748T User Manual

272
GS748T Smart Switch
System Setup and Maintenance
Feature Sets Supported Default
Boot code update 1 N/A
DHCP/manual IP 1 DHCP enabled/192.168.0.239
Default gateway 1 192.168.0.254
System name configuration 1 NULL
Configuration save/restore 1 N/A
Firmware upgrade 1 N/A
Restore defaults 1 (Web and front-panel button) N/A
Dual image support 1 Enabled
Factory reset 1 N/A
Feature Sets Supported Default
Multi-session Web connections 16 Enabled
SNMPv1/V2c
SNMP v3
Max 5 community entries Enabled (read, read-write
communities)
Time control 1 (Local or SNTP) Local Time enabled
LLDP/LLDP-MED All ports Disabled
Logging 3 (Memory/Flash/Server) Memory Log enabled
MIB support 1 Disabled
Smart Control Center N/A Enabled
Statistics N/A N/A
IPv6 management (IPv6
ne
tworking, DHCPv6, IPv6 DNS
host, IPv6 ping, etc.)
N/A N/A
System Management

NETGEAR GS748T Specifications

General

Basic switching RJ-45 Ethernet ports quantity	48
MAC address table	16000 entries
Packet buffer memory	1.632 MB
Maximum data transfer rate	1 Gbit/s
Latency	20 µs
I/O ports	48 RJ-45 connectors for 10BASE-T, 100BASE-TX, and 1000BASE-T (Auto Uplink on all ports) 4 SFP slots for fiber Gigabit Ethernet modules
Dimensions (WxDxH)	440 x 260 x 43 mm
Power requirements	100-240VAC 50/60 Hz
Networking features	10BASE-T, 100BASE-TX, 1000BASE-T
Connectivity technology	Wired
Full duplex	Yes
Networking standards	IEEE 802.3x
Minimum system requirements	Category 5 network cables Network card for each PC Network software (e.g., Windows)
Mean time between failures (MTBF)	69930 h
Safety	UL listed (UL 1950)/cUL, IEC950/EN60950
LED indicators	Link, Power
Power consumption (typical)	70 W
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	4000 g