Troubleshooting
133
Trek N300 Travel Router and Range Extender PR2000
WiFi LED is Off
If the WiFi LED stays off, check to see if the Enable Wireless Router Radio check box on
the Advanced Wireless Setting screen is selected. The WiFi LED is lit when the wireless
radio is turned on.
Log in to the Trek with an Ethernet cable to check this setting. For more information, see
Advanced Wireless Settings on page 113.
Cannot Log In to the Trek
If you cannot log in to the Trek from a computer on your local network, check the following:
• If you are using an Ethernet-connected computer, check the Ethernet connection
between the computer and the Trek. For more information, see
Check Ethernet Cable
Connections on page 131.
• Make sure that your computer’s IP address is on the same subnet as the Trek. If you are
using the recommended addressing scheme, your computer’s address is in the range of
192.168.168.2 to 192.168.168.200.
• If your computer’s IP address is shown as 169.254.x.x, recent versions of Windows and
Mac OS generate and assign an IP address if the computer cannot reach a DHCP server.
These autogenerated addresses are in the range of 169.254.x.x. If your IP address is in
this range, check the connection from the computer to the Trek, and reboot your
computer.
• If your Trek’s IP address was changed and you do not know the current IP address, clear
the Trek’s configuration to factory defaults. This sets the Trek’s IP address to
192.168.168.1. For more information, see
Factory Settings on page 143.
• Make sure that your browser has Java, JavaScript, or ActiveX enabled. If you are using
Internet Explorer, click the Refresh button to be sure that the Java applet is loaded.
• Try quitting the browser and launching it again.
• Make sure that you are using the correct login information. The factory default login name
is admin and the password is password. Make sure that Caps Lock is off when you enter
this information.
• If you are attempting to set up your NETGEAR Trek as an additional router behind an
existing router in your network, consider replacing the existing router instead. NETGEAR
does not support such a configuration.
• If you are attempting to set up your NETGEAR Trek as a replacement for an ADSL
gateway in your network, the Trek cannot perform many gateway services, for example,
converting ADSL or cable data into Ethernet networking information. NETGEAR does not
support such a configuration.
To Next Page
Loading...
Need help?
General
