Hardware Setup
17
Trek N300 Travel Router and Range Extender PR2000
The Wireless as WAN screen displays, which shows the available wireless networks.
6. Make sure that the Extend my current wireless router's range check box is not selected.
7. Select the wireless network that you want to connect to and enter the related security
information for that wireless network.
8. T
o be able to use these settings again without having to reenter them, select the To save a
name for profile check box.
9. In the field provided, enter a name for the profile.
10. Click the Apply button.
The Trek is connected to the WiFi hotspot after a two-minute setup process.
11. (Optional) Connect your wireless devices to the T
rek.
For more information, see Add Wireless Devices or Computers to Your Trek on page 32.
12. (Optional)
To use a USB device, connect it to the USB port of the Trek.
A USB device can be a USB storage drive or a USB printer. When the Trek is plugged into
the wall,
the USB port can also be used as a cell phone charger. For more information,
see Enhance Your Local Network on page 71.
WiFi Range Extender Setup
Use the Trek as a WiFi extender to connect your wireless devices that are outside the range
of your existing WiFi router.
NETGEAR recommends that you connect to the WiFi network of the Trek when a wireless
device is in a dead zone where the connection to your existing WiFi router is poor or
nonexistent.
To Next Page
Loading...
Need help?
General
