Nikon D300 - Necessary Adjustments When Parts Are Replaced; D300 Adjustment Software and Updates

VBA20001-R.3720.A
- Ａ 40 ・ -
logo�Q0310�forGraphic
070509�Gdesign�ito
1. D300 adjustment software and updates
Adjustments
Replacement parts
Writing of
EEPROM
xed
values
AE CCD
positioning
adjustment
AE
accuracy
inspection &
adjustment
Aperture
accuracy
inspection
Built-in SB
light volume
inspection &
adjustment
Battery
check volt-
age level
adjustment
AF
accuracy
inspection &
adjustment
Shutter unit
Main PCB unit
○ △ ○ ○ ○ ○ ○
AF FPC unit
○
Top cover or
SB lower case unit
○
DCDCAK
base plate unit
○
DCDCSZ
base plate unit
Metering FPC unit
○ ○
I base plate unit
○
＊
1.When the shutter is replaced, make the image shutter adjustment by using the image adjustment software.
＊
2.When the main PCB unit is replaced, be sure to update the version before writing the xed values.
＊
3.Make the inspection.
＊ 3
＊ 2
＊ 1
Necessary adjustments when parts are replaced
Changed Page
△
×1
Ｍ
サービス
計画課
△
(Revision) update the rmware after "writing of xed value", and then perform "writing of xed value" again.
Feb.1st.2008
INC