select
Current position
. To select the location from
the map, select Select from map. To enter the
position information manually, select
Enter
manually
.
● Edit
— Edit or add information to a saved landmark
(for example, a street address).
●
Add to category
— Add a landmark to a category
in Landmarks. Select each category to which you
want to add the landmark.
● Send — Send one or several landmarks to a
compatible device. Your received landmarks are
placed in the Inbox folder in Messaging.
You can sort your landmarks into preset categories, and
create new categories. To
edit and create new
landmark categories, open
the categories tab, and
select Options
> Edit categories
.
GPS data
Route guidance
Select
> Applications
>
GPS data
and
Navigation
.
Start the route guidance ou
tdoors. If started indoors,
the GPS receiver may not receive the necessary
information from the satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the
destination, and the approx
imate distance to it is
shown inside the compass ring.
Route guidance is designed
to show the straightest
route and the shortest distance to the destination,
measured in a straight line. Any obstacles on the route,
such as buildings
and natural obstacles, are ignored.
Differences in altitude are not taken into account when
calculating the distance. Rout
e guidance is active only
when you move.
To set your trip destination, select
Options
> Set
destination
and a landmark as the destination, or
enter the latitude and longitude coordinates.
To clear the destination set for your trip, select
Stop
navigation
.
Trip meter
Select
> Applications
>
GPS data
and Trip
distance
.
The trip meter has limited accuracy, and rounding
errors may occur. Accuracy can also be affected by
availability and quality of GPS signals.
To turn trip distance calculation on or off, select
Options
> Start orStop
. The calculated values remain
on the display. Use this feature outdoors to receive a
better GPS signal.
To set the trip distance and time and average and
maximum speeds to zero, and to start a new
calculation, select
Options
> Reset
. To set the trip
meter and total time to zero, select
Restart
.
31
Positioning
Cyan
To Next Page
Loading...
Need help?
General
