Norstar Orientation /
21
Norstar Programming Record: The Norstar Modular
Programming Record provides a convenient way of recording the
settings for your system. Your Installer or Service Representative
will fill in the Configuration settings, and may then leave the
Programming Record with you for your records. If you do not have
a copy of the Programming Record, you may record all of your
Administration settings in the Job Aids chapter of this Guide. The
Programming Record (or the Job Aids chapter) is represented in
this Guide by the following symbol:
When you see this symbol, remember to record the
changes you make in the appropriate area of the
Programming Record or the Job Aids chapter of this
Guide.
Default Settings
If you are performing Administration on a new system, you will find
that many of the settings are pre-selected. These are called the
default settings. You have the option of leaving them as they-are,
or changing them.
Administration Flow Charts
The Administration Headings Flow Chart is a convenient overview
of Norstar Administration that should help you to follow the
Orientation Tour and understand the system. A simplified flow
chart illustrating the steps under each heading follows the
procedures in each of the eight Administration sections of the
Administration chapter.
In the Flow Charts chapter at the back of the Guide, you will find
the charts in complete detail. After you have tried a few
Administration tasks and read the general descriptions that follow,
you may find that you can perform Administration using only the
flow charts for reference.
System Coordinator Guide
i.-
To Next Page
Loading...
Need help?
General
