Norstar M7324 User Manual

..i.:. .;,
..,
I.-: :, _ .G’.
_. ‘/
.-
.I-, ‘.,-,
,:,.: :.
., : -.,
Administration / 41
Entering Administration:
1.
Release all calls on your M7324 or M7310 telephone.
Indicators for calls on other telephones stay ON.
2. Enter the following code: mllr”71*1i?/E]r%jmII
3.
If the display changes to 1 Password : 1, enter
the Administration password. If the proper password is
entered, the display changes to
I1.ScJs
and three triangular indicators )appear on the LCD
panel between the rows of buttons.
If no password is required, the p Sys speed d I c1 I 1
display and the indicators appear as soon as the
Administration code is entered.
4.
Place the Overlay over the four buttons pointed to by the
indicators.
5. Press I] twice. The display changes to
13. T i me and date ] You are now at the starting
point for each of the following procedures.
To change the Time:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Begin with ) 3. T i me and date ] on theddisplay, then
follow the steps below. This example uses the setting
3:45 pm, March 31, 1989.
Press m] The display shows] T i me
15: 45
1
Press -1 The display shows
IHour: 15
I If you do not wish to change this
setting, go to step 5 below.
Press -1 The previous Hour setting is erased.
Enter the desired digit(s) from the dialpad.
Press m The display shows 1 M i nu tcs : 43
If you do not wish to change this setting, go to step 8
below.
Press -1 The previdus Minutes setting is erased.
Enter the desired digit(s) from the dialpad.
Press (1
If the display shows1 Date 3 1 Mar 89 ], follow step
11 below.
If the display shows m or m , follow step 9
below.
Choose the proper FI M $ P M setting by pressing the
m display button.
10. Press m The display shows I Date 3 1 Mar 89 I
11. Proceed to change the date or follow the Exit procedure
on the next page.
System Coordinator Guide
2..-

Norstar M7324 Specifications

General

Brand	Norstar
Model	M7324
Category	Telephone
Language	English