50
/Administration
To copy line Restrictions
Begin with 1
4.
Restr i ct i 01-1s 1 on the display, then follow the
steps below.
Press JShowl The display shows)
Tab I e en tr i es
Press m The display shows
]App I i Ed to I i t-1~5 1
Press -1 The display changes to
IShow I ine:-
Press them button under the display.
The display shows I~~urcc : _
Enter the two-digit line number of the line to be copied.
The display changes to
I Co -1
Enter the two-digit line number of the line to receive the
new Restrictions. The display temporarily shows
)
Cop
i
ed
XX to YY I with appropriate line numbers in
place of the Xs and Vs. The display then changes to
1 cu
-1 You may now copy the same
Restrictions to another line.
When you are finished, follow the Exit ~procedure on the
next page.
6.
7.
To copy 1 set Restrictions:
Begin with (
App
I i
ed
to sets
(on the display.
Follow steps 3-7 from the ‘Copy line Restrictions” procedures.
All
display messages are the same, but “sets” will appear instead of
“lines”.
Restrictions Exit procedure:
To move to other Administration tasks:
1. Press 1-1 once-or several times until the display
shows\ 4. Restrictions (
2. Press m or (Backl to move to another heading.
To Exit from Administration:
1. Press I
System Coordinator Guide
5. -
To Next Page
Loading...
Need help?
General
