- 59 -
4. Print
How to Print from the MP Tray
This section explains how to load paper in the MP Tray and print from the MP Tray.
Regarding media flexibility, please refer to "
Supported Paper", "Paper Loaded on the Tray".
• Do not load paper of different sizes, types or weights at the same time.
• When adding paper, remove the paper on the MP tray and straighten the edges of both stacks of paper, and then
load them again.
• Do not put anything other than paper for printing in the MP tray.
• Do not leave paper in the MP tray for a long time. Dust and dirt will adhere to the paper and cause print quality to
deteriorate.
1
Open the MP tray (1) forward by inserting your fingers into the front recesses
(2).
2
Pull out the paper supporter (3) by holding the center part of it.
3
Unfold the sub support (4).
4
Open the paper set cover (5).
5
Adjust the manual feeding paper guide (6) to the width of paper to be loaded.
6
Insert the paper with the print side face up.
To Next Page
Loading...
Need help?
General
