BASIC COPY MODES
- 43 -
● BASIC COPY MODES
Before Using Copying Functions
Default settings
This equipment is under its “default settings” when the power is
turned ON, namely, if no setting change has been applied yet,
the equipment’s settings return to the default ones when the
energy saving mode is cleared or the [RESET] button on the
control panel is pressed. The default settings for basic copy
modes at installation are shown below.
The default settings are changeable.
Confirming the set functions
If you press [SETTINGS] on the touch panel, the menu shown
below is displayed. On this menu, you can view the functions
that are currently set.
Switching to the function setting menu
To change the functions on the current menu, press the
corresponding buttons. The desired setting menu will then
appear.
Clearing the set functions
If you want to clear any copy function setting, press [RESET]
on the corresponding setting menu.
However, for FULL IMAGE on the EDIT menu, also press the
highlighted button to clear the setting.
Clearing all settings changed
When you press the [RESET] button on the control panel, all
the function changes will be cleared.
Item Default setting
Reproduction ratio 100%
Copy quantity 1
Paper selection Automatic Paper Selection
(APS)
Simplex/Duplex 1-sided original -> 1-sided copy
Density adjustment Manual adjustment
Color mode FULL COLOR
Original mode TEXT/PHOTO
Finishing mode When using the original glass:
NON-SORT NON-STAPLE
When using the RADF
(Reversing Automatic Document
Feeder):
SORT
Feeding mode when using the
RADF
Continuous feed mode
To Next Page
Loading...
Need help?
General
