4
Select [SORT] or [GROUP], and then press
[OK].
5
Key in the desired number of copies.
6
Select other copy modes as required, and
then press the [START] button on the
control panel.
Staple sort mode
When you make more than one set of copies, the copied paper
can be automatically stapled set by set. This mode is called the
staple sort mode. You can choose from 2 different stapling
positions.
Example: When [LEFT] is selected
Note
• Special paper such as OHP film or sticker labels is not
applicable.
• Copies in different sizes cannot be stapled unless their
length is the same.
1
Place paper in the tray(s).
When using bypass copying, be sure to set the paper
size.
2
Place the original(s).
3
Press [FINISHING] on the touch panel.
4
Select the desired stapling position from
[LEFT] or [RIGHT] and then press [OK].
5
Select other copy modes as required, and
then press the [START] button on the
control panel.
Memo
• When the number of sheets exceeds the maximum
number of sheets available for stapling, this equipment
automatically enters into the sort mode.
To Next Page
Loading...
Need help?
General
