Memo
• You can store data in an e-Filing box with the Store to e-
Filing function. For details, refer to the e-Filing Guide.
1
Place the original(s).
2
Press [STORAGE] on the touch panel.
3
Press [COPY & FILE] on the touch panel.
4
Press the necessary buttons for entering
information about the data to be stored.
Then press [OK].
MFP LOCAL: Press this to store the data into the share
folder of this equipment.
REMOTE 1, REMOTE 2: Press either of them to store the
data into the share folder of a PC that is connected
with this equipment via a network.
Note
• You can select up to 2 of [MFP LOCAL], [REMOTE 1]
and [REMOTE 2]. You can cancel the selected item by
pressing the same button again.
• When a user who has the privilege of changing the
setting of [REMOTE 1] and [REMOTE 2] has pressed
either of them, the menu for specifying a directory
appears. In this case, see the following page to specify
the directory:
P.58 "Setting share folder"
FILE NAME: Press this to display the on-screen
keyboard. Then enter the file name within 128 letters.
Note
• The trailing characters in a file name (maximum 74)
may be deleted depending on the type of letters used.
FILE FORMAT: Select the file format in which the data
are stored from PDF, TIFF or XPS.
MULTI / SINGLE: These are for selecting whether the
data are stored as a multiple page file or a single page
file. If you select “MULTI”, all the scanned data will be
stored as one file. If you select “SINGLE”, a folder is
created and each page of the scanned data will be
stored individually as one file in the folder.
5
Press the [START] button on the control
panel.
When the original is placed on the RADF (Reversing
Automatic Document Feeder), copying and storing start
simultaneously.
When the original is placed on the original glass, follow
the procedure below.
6
Place the next original on the original glass,
and then press [NEXT COPY] on the touch
panel or the [START] button on the control
panel.
Repeat this step until the scanning of all the originals is
finished.
7
When all have been scanned, press [JOB
FINISH] on the touch panel.
Copying and storing start.
To Next Page
Loading...
Need help?
General
