Chapter 12: Miscellaneous Commands 131
Parameters L
n
and H
n
Parameters L
n
and H
n
are used to designate the quantity of data, as follows:
L
n
+ (H
n
x 256)
Parameter P
n
Parameter P
n
sets the increment of movement. It can have any value from 0 to 255.
Table 101: Epson ESC ( U Command —
Increments of Movement for P
n
Values
P
n
Increment
0 to 9 Unchanged
10 to 19 1/360"
20 to 29 11/80"
30 to 39 1/120"
40 to 49 1/90"
50 to 59 1/72"
60 to 69 1/60"
70 to 255 Unchanged
Software I-Prime Command (IBM/E/ML)
⻬ ML320 Turbo, ML321Turbo ⻬ ML520, ML521
⻬ ML390 Turbo, ML391Turbo ⻬ ML590, ML591
Function ASCII Dec Hex
Software I-Prime ESC } NUL 27 125 0 1B 7D 00
This command clears the print buffer and resets the printer to the default settings, regardless of
the setting for the Reset Inhibit item in the printer menu.
If the Cut Sheet Feeder (CSF) is installed, this command will also eject any paper loaded into
the printer from the CSF.
Stop Printing Command (IBM)
⻬ ML390 Turbo, ML391Turbo ⻬ ML590, ML591
Function ASCII Dec Hex
Stop Printing (Deselect) ESC j 27 106 1B 6A
This command deselects the printer so that it will stop printing. To resume printing, press the
SEL switch, or–if “Auto Select” is set to “Yes” in the menu–reload paper.
To Next Page
Loading...
Need help?
General