Chapter 2: Character Set Commands 7
Print One Character from IBM All Character Set [IBM Set III] Command (IBM)
⻬ ML320 E/I, ML321 E/I ⻬ ML320 Turbo, ML321 Turbo ⻬ ML520, ML521
⻬ ML390 Turbo, ML391 Turbo ⻬ ML590, ML591
Function ASCII Dec Hex
Print Specified Character from IBM Set III ESC ^ n 27 94 n 1B 5E n
This command will print only the one character you specify within the command, using IBM
Character Set III (also known as the All Characters set).
When the printer receives this command, it will print the character “n” from IBM Character Set
III. The value of n can be from 0 to 255 decimal (00 to FF hexadecimal).
Epson Character Set Commands
Select Epson Set 1 [Slanted Characters] Command (Epson)
⻬ ML320 E/I, ML321 E/I ⻬ ML320 Turbo, ML321 Turbo ⻬ ML520, ML521
⻬ ML390 Turbo, ML391 Turbo ⻬ ML590, ML591
Function ASCII Dec Hex
Select Epson Set 1 ESC t 0 27 116 48 1B 74 30
In the Epson emulation, this command specifies Epson Character Set 1 for the upper ASCII
range (decimal 128 to 256). Epson Character Set 1 contains slanted characters, equivalent to
italics.
Select Epson Set 2 [Graphics Characters] Command (Epson)
⻬ ML320 E/I, ML321 E/I ⻬ ML320 Turbo, ML321 Turbo ⻬ ML520, ML521
⻬ ML390 Turbo, ML391 Turbo ⻬ ML590, ML591
Function ASCII Dec Hex
Select Epson Set 2 ESC t 1 27 116 49 1B 74 31
In the Epson emulation, this command specifies Epson Character Set 2 for the upper ASCII
range (decimal 128 to 256). Epson Character Set 2 contains graphics characters.
To Next Page
Loading...
Need help?
General