Operation 23
English
3. Open the rear of the printer, as shown above, and make sure any
pieces of paper are removed from inside of the printer.
4. Close the rear of the printer.
5. Load continuous paper onto the front paper feed. Refer to Front
Paper Feed Loading in Set Up.
Cleaning
The printer should be cleaned every six months or after approximately 300
hours of operation.
Caution
Never use solvents or strong detergents on the printer housing as these could
cause damage to the printer housing.
1. Turn the printer off and remove the paper from the front and rear
paper feeds.
2. Open all access covers and, using a clean dry cloth, dust around
inside the printer removing any loose pieces of paper.
3. Reload continuous paper onto the front and rear paper feeds.
4. Close all access covers and turn the printer on.
To Next Page
Loading...
Need help?
General
