Epson FX Mode 61
English
Note:
At power up, the VFU channel n is set to 0.
MISCELLANEOUS FEATURES
Delete Last Character
The CHR$(127) code deletes the last character data that was input in the
print buffer.
If the code to be deleted was a space, CHR$(32), one space will be deleted
on receipt of this command. If the last data was a horizontal tab skip, then
only one space will be deleted—not the whole skip. If the data which is to
be deleted is in the form of Bit Image Graphics data then this command is
ignored.
Master Reset
The printer can be reset to its default menu settings, print buffer cleared,
and Top Of Form set to the current print head position. If RESET INHIBIT
is YES in the menu, this command will be ignored.
Print Suppress
After the printer has received the DC3 code, it will ignore all further data
sent from the host until the code DC1 is received. The data will not be
stored or printed.
During the time that the printer is in this mode the ONLINE indicator will
flash. The printer can only be reselected with DC1—the ONLINE button
will not reselect the printer.
Note:
The PRINT SUPPRESS option in the menu must be
set to YES in order for these commands to be active.
If this option is set to NO, the commands will be
Delete last character Decimal Hex. ASCII Comp.
Delete last character 127 7F DEL F
Master reset Decimal Hex. ASCII Comp.
Master reset 27 64 1B 40 ESC @ F
Print suppress Decimal Hex. ASCII Comp.
Print suppress on 19 13 DC3 F
Print suppress off 17 11 DC1 F
To Next Page
Loading...
Need help?
General
