34
EN
Shooting
2
“Point-and-shoot” photography (P program mode)
P mode is a shooting mode where the camera automatically sets the optimal aperture
and shutter speed according to subject brightness. Set the mode dial to P.
250250 F5.6
01:02:0301:02:03
3838
L
N
P
ISO-A
200
0.00.0
FullHD
F
S-IS AUTO
S-IS AUTO
Wi-Fi
Shooting mode
Shutter speed
Aperture value
• The functions you can set with the dials depend on the position of the lever.
Front dial
Lever
Rear dial
Dial
Position of the lever
12
r
Exposure
compensation
ISO
o
Program shift White balance
• The shutter speed and aperture selected by the camera are displayed.
• The shutter speed and aperture displays will blink if the camera is unable to achieve
correct exposure.
Warning display
example (blinking)
Status Action
60"
F2.8
The subject is too
dark.
• Use the fl ash.
8000
F22
The subject is too
bright.
• The metered range of the camera is
exceeded. A commercially available ND
fi lter (for adjusting the amount of light) is
required.
• The aperture value at the moment when its indication blinks varies with the lens type and
focal length of the lens.
• When using a fi xed [ISO] setting, change the setting. g [ISO] (P. 54 )
Program shift (%)
In P and ART modes, you can choose different
combinations of aperture value and shutter speed without
altering exposure. An “s” appears next to the shooting
mode during program shift. To cancel program shift, press
FG until “s” is no longer displayed.
Cautions
• Program shift is not available when you are using a
fl ash.
250250 F5.6
01:02:0301:02:03
3838
L
N
ISO-A
200
0.00.0
FullHD
F
S-IS AUTO
S-IS AUTO
P
s
Wi-Fi
Program shift
To Next Page
Loading...
Need help?
General
