Omron FS-C2KU7DGES-C User Manual

No.20S046-00
30/62
FS-C4KU7DGES-F / FS-C4KU7DGES-M42 / FS-C2KU7DGES-F / FS-C2KU7DGES-M42 / FS-C2KU7DGES-C
Product Specifications and Use’s Guide
10 Camera Functions
10.1 Save and load the camera settings
The camera has the camera setting save function, and camera setting including factory default loads
function.
The camera has below two type of camera settings.
Default: The factory default settings (This setting cannot change)
UserSetX: Over writeable camera settings (X: 0 to 7)
These camera settings load from ROM to register in RAM on camera, and camera settings at register in RAM
on camera save to ROM.
The camera settings saving and loading are controllable with Parameters (“UserSetSelector”,
“UserSetDefault”), and commands (“UserSetLoad”, “UserSetSave”) in “UserSetControl” category of
GenICam.
The details of the parameters and the functions are in the table below:
GenICam Parameters
UserSetSelector IEnumeration Type Select “Default” or ”UserSetX”
“UserSetLoad” or “UserSetSave” process for selected settings.
UserSetLoad ICommand Type The camera settings load from ROM to register in RAM.
UserSetSave ICommand Type The camera settings at register in RAM save to ROM.
UserSetDefault IEnumeration Type Select which settings (“Default” or “UserSetX”) load automatically when camera
power is on. This selection saves automatically.
Saving Camera Settings
Setting Procedure
1. Selects “UserSetX” at “UserSetSelector”
2. Execute “UserSetSave”
When executing “UserSetSave”,
camera settings at the register in RAM are
saved to the ROM that is selected at
“UserSetSelector”.
Caution:
“UserSetSave” CANNOT execute when
“Default” was selected at “UserSetSelector”
ROM
UserSet0 to 7
ROM
Default
Camera
Settings
UserSetSelector
Selector

Omron FS-C2KU7DGES-C Specifications

General

Brand	Omron
Model	FS-C2KU7DGES-C
Category	Digital Camera
Language	English