• The part number for this cable is 13463-000.
• The length of this cable is 600 mm.
Additional Information
Refer to A-5-2 XBELTIO Adapter Cable Pinouts on page A-8 for more information.
Belt Encoder Y-adapter Cable
The optional belt encoder Y-adapter cable connects to the XBELTIO adapter cable's BELT ENCODER
connector. This cable provides individual connections for two belt encoder input signals.
• The part number for this cable is 09443-000.
• The length of this cable is 3 m.
Additional Information
Refer to A-5-3 Belt Encoder Y-adapter Cable Pinouts on page A-9 for more information.
XIO Breakout Cable
The optional XIO breakout cable connects to the XIO connector on the Primary Interface Panel and
provides a method to connect I/O devices directly to the robot without using an IO Blox unit.
• This cable is not compatible with the XIO Termination Block.
• The part number for this cable is 04465-000.
• The length of this cable is 5 m.
Additional Information
Refer to 3-7-1 XIO Connector Signals and Wiring on page 3-13 for more information.
XIO Cable
The optional XIO cable connects to the XIO connector on the Primary Interface Panel. It is used to
connect an XIO Termination Block to the system.
• The part number for this cable is 03695-000.
• The length of this cable is 2 m.
Additional Information
Refer to 1-6-4 XIO Termination Block on page 1-16 for more information.
EXPIO to IO Blox Cable
The optional EXPIO to IO Blox cable connects to the XBELTIO adapter cable's FORCE/EXPIO con-
nector. It allows a direct connection between this connector and optional IO Blox units.
• The part number for this cable is 04677-030.
• The length of this cable is 3 m.
1 Overview
1-18
i4L Robots User's Manual (I658)
To Next Page
Loading...
Need help?
General
