Pioneer PDP-4270XD User Manual

Watching TV 06
21
En
English
Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner must be
set up. See Setting up TV channels on page 25 for how to do this.
Turning the power on
• To turn on the system, press POWER on the bottom-left of
the front of the plasma television.
The POWER ON indicator lights blue.
• To switch the system back into standby, press  on the
remote control unit or STANDBY/ON on the plasma television’s
control panel on the right-hand side.
The STANDBY indicator lights red.
• You can then turn on the system again by pressing  or 0 to 9 on
the remote control or STANDBY/ON on the plasma television. If
you press 0 on the remote control unit, images come from the
INPUT 1 source. If you press 1 to 9, TV images display.
• You can also press POWER on the plasma television to turn off the
system. However, you cannot then turn on the system again by
pressing the buttons on the remote control unit or STANDBY/ON
on the plasma television.
Note
• We recommend not unplugging the plasma television from the
power outlet when it is not in use. In standby, the plasma television
automatically receives Electronic Programme Guide and DTV Auto
Update signals.
• When the system is placed into standby mode, the main power
flow is cut and the system is no longer fully operational. A minute
flow of power feeds the system to maintain operation readiness.
• If you are not going to use the plasma television for several days,
be sure to remove the power cord from the power outlet.
Plasma television status indicators
The table below shows the operational status of the plasma television.
You can check the current status of the system with the indicators on
the plasma television.
For other than the above, see Troubleshooting on page 56.
Changing channels
Use the remote control or the control panel on the right-hand side of
the plasma television to change channels.
Switching between the TV and DTV modes
• Press INPUT on the plasma television or TV/DTV on the
remote control unit to select the DTV or TV input mode.
TV/DTV
Indicator status System status
POWER ON STANDBY
The power cord of the plasma television has been
disconnected. Or, the power cord of the plasma
television has been connected but the POWER button
of the plasma television is off.
Power to the system is on.
The system is in the standby mode.
TV/DTV
8
AAA
STEREO
10:00
STANDARD
FULL
Channel display
PDP4270XD_En.book Page 21 Friday, June 16, 2006 5:32 PM

Pioneer PDP-4270XD Specifications

General

Depth	115 mm
Width	1040 mm
Height	679 mm
Weight	32100 g
Comb filter	3D
Pixel pitch	- mm
Aspect ratio	16:9
Product color	Black
Noise reduction	Yes
RMS rated power	13 W
Display diagonal	42 \
Channels quantity	99 channels
Display brightness	1100 cd/m²
Display resolution	1024 x 768 pixels
Display technology	Plasma
Power requirements	AC 220 - 240 V, 50/60 Hz
SCART ports quantity	3
Contrast ratio (typical)	3000:1
Analog signal format system	PAL, SECAM
Power consumption (standby)	0.7 W
Power consumption (typical)	291 W