Using the Electronic Programme Guide (EPG)10
42
En
• To watch a programme currently on air, select the programme
(then ENTER).
• You can check information about programmes scheduled up to 1
week ahead, depending on conditions.
• Depending on conditions, it may take some time to acquire EPG
data.
3 To view more information (not currently displayed) about the
selected programme, press p.
Detailed information appears in the schedule window.
• If the screen contains further information, "More" is displayed.
Press the BLUE button to display all the available information.
• To quit the display of detailed information, press p again (or
RETURN).
4 To quit the Programme Guide, press EPG again.
Note
• The general programme list does not show finished programmes.
Using TV programme presets
Using the EPG, you can easily preset digital TV programmes for
watching (auto channel select) and recording later.
You must also adjust your recording equipment settings to record the
programme. Refer to the operation manual provided with your
recording equipment.
Using auto channel select and standby recording
With the power to the system left on, this function automatically
selects a preset TV programme when its on-air time comes. That way
you will not miss the start of an important TV programme because you
were enjoying another TV programme.
Even if the system is in the standby mode when the preset TV
programme's on-air time comes, the built-in DTV tuner wakes up and
outputs AV signals for recording.
1 Press EPG.
The EPG screen appears.
2 Select a programme to be preset (/// then ENTER).
• Select a programme not yet started.
• A setup menu appears.
• Select a programme currently on-air (then ENTER): The EPG
screen closes and a channel is tuned in.
• Select a programme currently on-air (then GREEN): The
programme can be set for recording/watching the next time (or
week) it is shown.
• Select a programme not yet started (then ENTER or GREEN): The
programme can be set for recording/watching.
3 Select “Yes“ in a confirmation dialogue box (/ then
ENTER).
The Programme Timer screen with a list of other preset programme
information appears.
• You can modify the presets here (/// then ENTER).
• You can register the presets here ( or ENTER).
4 Press RETURN to return to the EPG screen.
• The EPG screen updates with the new presets.
• A red clock icon appears for the preset programme.
• A yellow triangle icon appears for overlapping presets.
5 Press EPG to exit the EPG screen.
With the system switched on, a channel switch alarm message
appears approximately 60 seconds before execution and the channel
is switched a short time before the start of the programme.
Note
• Auto channel select is not executed when the system is in the
standby mode.
• Even in the standby mode, preset programmes can be recorded as
only the built-in DTV tuner wakes up and outputs AV signals when
the preset time comes.
• Finish presetting operations three minutes before the start of the
programme.
001
************
14:0513:40 -
*************
**************************
More
02
03
04
05
06
07
08
09
10
Every Day
Every Sun
Mon-Fri
Sat, Sun
01 Mon.05.Jan
No.
Programme Timer
Date
14:00-15:00
14:00-15:00
14:00-15:00
14:00-15:00
12:00-13:00
Time
007
***************
007
***************
007
***************
007
***************
001
************
Channel Info
Wed.24.Nov 12:34
PDP4270XD_En.book Page 42 Friday, June 16, 2006 5:32 PM
To Next Page
Loading...
Need help?
General
