2
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
2.45
4. The X measurement should be 1/8″ - 1/4″ inch (3 - 6
mm) greater than the Y measurement.
NOTICE
Image for reference only.
MEASUREMENT
AXYS Ski Toe Setting (Overall):
1/8″ - 1/4″ inch (3 - 6 mm)
Ski Alignment / Toe Adjustments
1. The track must be aligned with the rear suspension to
provide accurate results. Verify the track tension and
alignment are set before proceeding.
2. Place a straight edge along the one side of the track.
Make sure that the straight edge is touching the
length of the track.
3. Record the measurements from the edge of the
straight edge to the forward ski mark (X) and the
rearward ski mark (Y). Use the ski skag as the ski
reference point.
4. Loosen the tie rod jam nuts and remove the rod ends
from the spindles. Adjust the tie rod so that both
measurements are the same.
5. Place the straight edge on the opposite side of the
track and measure the opposite ski marks.
6. Adjust the tie rod so that both measurements are the
same.
7. Steps 2 to 6 will align the skis with the track. At this
point, verify the handlebar is centered with the skis.
8. Turn both tie rods equally to set ski toe. When
finished, measurement (X) should be 1/8″ - 1/4″ inch
(3 - 6 mm) wider than measurement (Y).
NOTICE
If setting toe on each ski using the alignment bar as a
reference point, (X) should be 1/16″ - 1/8″ (1.6 - 3 mm)
wider than measurement (Y).
9. Torque steering tie rod jam nuts and spindle fasteners
to specification.
TORQUE
Tie Rod Spindle Fasteners:
37 ft-lbs (50 Nm)
Rod End Jam Nuts:
11 ft-lbs (15 Nm)
MAINTENANCE
To Next Page
Loading...
Need help?
General
