3.102
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
6. Remove the recoil ratchet
r
and recoil friction spring
t
.
NOTICE
Note the orientation of these components during
removal.
7. Remove the recoil spacer
y
, recoil washer
u
, and
recoil return spring
i
from the reel.
8. Carefully lift up on the reel
o
. Turn the reel counter-
clockwise to disengage the recoil spring from the reel.
RECOIL HOUSING ASSEMBLY
1. If the recoil spring reel
q
was removed during
disassembly, install the spring by spiraling the recoil
spring counterclockwise toward the center of the
housing. The outer spring loop fits on the pin in the
housing.
2. Lubricate the center shaft and spring with Polaris
Premium grease.
3. If installing a new recoil rope on the reel, use a utility
knife to remove the silicone from the knot housing on
the reel.
4. Remove the old rope and replace with new. Use a
double overhand stopper knot to secure the new rope
to the reel.
5. After tieing the knot, push the knot into the housing so
that it is flush with the outer surface. Fill the knot
housing with RTV-Black silicone and allow to cure.
6. Wind the rope counterclockwise around the reel as
viewed from the ratchet-side of the reel.
7. Pass the end of the rope through the hole in the
housing. If the rope guide was removed from the
housing, reinstall it before attaching the rope handle.
8. Slide the reel
w
down the center shaft and into the
housing making sure the recoil spring re-engages the
reel tab.
ENGINE / COOLING / EXHAUST
To Next Page
Loading...
Need help?
General
