6
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
6.11
CHAINCASE OIL CHANGE - PUMP
METHOD
NOTICE
This procedure requires the use of a commercially
available hand pump oil extractor.
1. Elevate the front of the snowmobile using a floor jack
or appropriate lift.
2. Remove the fill plug
q
. Clean all metal shavings off
the plug.
3. Insert the tube of a hand pump oil extractor into the fill
hole. Direct the hose toward the bottom front area of
the cover, away from the chain / sprocket.
4. Extract the oil from the chaincase.
5. Lower the snowmobile.
6. Using a funnel, slowly add the recommended oil until
the fluid begins to overflow.
FLUID CAPACITY
Maximum Fluid Capacity:
10.5 oz. (310 ml)
7. Clean the area with a clean, dry shop towel.
8. Reinstall the fill plug. Torque plug to specification.
TORQUE
Chaincase Fill Plug:
4 ft-lbs (6 Nm)
CHAINCASE OIL CHANGE - COVER
DRAIN METHOD
1. Position snowmobile on flat, level surface.
2. Remove the two screws
q
securing the fender to the
chaincase.
3. Remove the right side panel. If equipped with a
battery, remove the battery and bracket.
NOTICE
When removing the battery, disconnect the BLACK (-)
cable first, and then disconnect the RED (+) cable last.
4. Place a drain pan under the chaincase.
FINAL DRIVE / BRAKE SYSTEMS
To Next Page
Loading...
Need help?
General
