9.2
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
GENERAL INFORMATION
GENERAL CAUTIONS AND NOTES
• Never re-use lock nuts. Always replace lock nuts that
have been removed with new parts.
• Never re-use pre-coated fasteners. Always replace
pre-coated fasteners with new parts.
• The side braces, bulkhead floor, and the front tunnel
cooler upper mating surface are bonded components.
• The only authorized bonding adhesive is Lord 406
Acrylic Adhesive. DO NOT USE ANY NON-
SPECIFIED BONDING ADHESIVE, GLUE, OR
EPOXY.
• Reference manufacture, production, and expiration
dates are printed on the container. Do not store this
product. Order a repair kit as required and dispose of
the product after the repair is completed in accordance
with local rules and regulations.
• Wear gloves, face mask, and protective eye wear
when removing original adhesive from chassis
components.
• Never apply excessive heat or flame to bonded
components when not intending to remove them from
the chassis.
• The engine overstructure / steering support assembly
and floor board support tubes are bonded
components. THESE COMPONENTS ARE NOT
SERVICEABLE. REPLACE AS COMPLETE
ASSEMBLIES.
• Bonded components must be removed, cleaned, and
re-bonded if the adhesive is subjected to temperatures
above 300 °F (149 °C).
• Adhesive working time is 6 to 10 minutes. Component
handling time is achieved within 60 minutes. Complete
cure time will take 24 hours at 68 °F (20 °C).
• Allow the adhesive to cure at room temperature 68 °F
(20 °C). Do not move the snowmobile outside (colder
temperature) while the adhesive is curing.
• Do not place the vehicle into service until the adhesive
has completely cured (24 hours).
CHASSIS
To Next Page
Loading...
Need help?
General
