7.12
FINAL DRIVE
12. Remove cotter pin, lower ball joint nut and A-arm from
ball joint.
13. Pull the strut assembly out and pull the drive-shaft out of
the hub. (Hubs removed for clarity - removal not required)
14. Pull both driveshafts from the front gearcase.
15. Remove the roller pin from the front prop shaft. Use the
Roller Pin Removal Tool (PN 2872608).
16. Remove bolts securing bottom of housing to frame. Bolts
are accessible through the skid plate. Remove vent line.
Remove the front gearcase from either side of frame.
DISASSEMBLY
1. Drain and properly dispose of used oil. Remove any metal
particles from the drain plug magnet.
2. Remove bolts and output shaft cover.
Front Gearcase Removal
Remove 4 Bolts
To Next Page
Loading...
Need help?
General
