9.3
ELECTRICAL
GEAR POSITION SWITCH
Switch Test
1. Locate the gear selector switch on the transmission.
Remove the wiring harness connector and insert the two
multimeter probes into the switch.
2. Move the gear selector handle to each of the three drive
positions (FWD, NEU, or REV).
3. Using an ohmmeter, test for continuity between the switch
contacts and connector leads. Replace the switch if no
continuity or high resistance is found.
RPM LIMIT MODES
Engine RPM is limited when:
• Operator selects reverse gear. The maximum vehicle
speed when reverse gear is selected is 6.5 MPH
• If the wheel speed sensor malfunctions, the
speedometer will limit engine RPM to approximately
3500 RPM when the transmission is in reverse.
• Maximum engine RPM is reached.
The reverse engine RPM limit can be overridden when the
operator presses and holds the override button.
On AWD models, the speedometer also limits the maximum
engine RPM in which the operator can engage the AWD
system. The speedometer will not allow the AWD to engage
when the engine RPM is at or above 3100 RPMs.
To Next Page
Loading...
Need help?
General
