9.29
ELECTRICAL
STARTER DRIVE
Pinion Gear - Anti-Kick Out Shoe, Garter
Spring Replacement
If the garter spring is damaged, the overrun clutch may fail to
return properly. Use either of the following methods to remove
and install a new garter spring:
1. Screw the overrun clutch out to the engaged position on the
pinion shaft assembly. Use a small piece of wire with the
end bent in a hook and pick the old spring out of its
channel. Slide it off the end of the shaft. Slide the new
spring over the overrun clutch and into the spring groove.
Make sure that the spring is positioned between the shoe
alignment pins and the back flange of the anti kick-out
shoes.
2. Remove the retaining ring, thrust washer, spring retainers
and clutch return spring. Screw the overrun clutch off the
end of the pinion shaft. Remove the old spring and install
a new one. Lightly grease the pinion shaft and reinstall the
clutch, spring, retainers, end washer and lock ring in the
reverse order. Make sure the end washer is positioned
properly so that it will hold the lock ring in its groove.
A. Gear Assembly
B. Thrust Washer
C. Busing
D. Retaining Ring
E. Thrust Washer
F. Stopper
G. Cover
H. Spring
A
B
C
D
E
F
G
H
To Next Page
Loading...
Need help?
General
