Polaris Hawkeye User Manual

9.12
ELECTRICAL
CDI OUTPUT TEST USING PEAK
READING ADAPTOR OR A
VOLTMETER
Re-connect all CDI wires to stator wires. Disconnect CDI
module wire from ignition coil primary terminal. Connect one
meter lead to engine ground and the other to the ignition coil
primary wire leading from the CDI module. Crank engine and
check output of CDI wire to coil. Reconnect CDI wire to the
coil.
CDI CRANKING OUTPUT TEST
The following peak voltage tests will measure the amount of
output from each component. A peak reading voltmeter can be
used to perform the tests. A variety of peak reading adaptors are
commercially available for use with the Fluke™ 77 Digital
Multimeter (PV-43568) and other digital VOMs which will
allow peak voltage tests to be performed accurately. Follow the
directions provided with the adaptor. All measurements are
indicated in Volts. Readings obtained without a peak reading
adaptor will be significantly different.
Disconnect the stator connectors from the CDI module. Test
output from the detection and pulse (trigger) coil, and compare
to the chart. The following measurements were obtained when
cranking the engine with the electric starter, spark plug
installed. The starting system must be in good condition and the
battery fully charged.
Test
Connect Meter
Wires To:
Reading
CDI Output
W/BLU to
Ground
200 - 250
Volts DC
Voltage
Test
Connect
Meter Wires
To:
Reading
(With VOM)
Reading
(With Peak
Reading
Adapter)
Pulse Coil W/R and B 0.15 Volts
minimum AC
@ cranking
RPM
5.3 - 5.4
Volts
minimum
DC @
cranking
RPM
Ohm
Test
Connect
Meter Wires
To:
Reading Reading
(With Peak
Reading
Adapter)
Pulse Coil W/R and B 520 Ohms n/a
W/R to
Ground
O.L.

Polaris Hawkeye Specifications

General

Brand	Polaris
Model	Hawkeye
Category	Offroad Vehicle
Language	English