MAINTENANCE
2.19
the right side of the ATV.
7. Remove the dipstick and wipe it clean.
8. Reinstall the dipstick completely
9. Remove the dipstick an check the oil level.
10. Add oil as needed to bring the level between the minimum
and maximum marks. Do not over fill.
11. Reinstall the dipstick.
OIL AND FILTER CHANGE
1. Set machine on a level surface.
2. Place the transmission in neutral.
3. Lock the parking brake.
4. Start the engine. Allow it to idle for two to three minuets.
5. Turn the engine off.
6. Clean the area around the drain plug.
7. Place a drain pan under the vehicle.
8. Remove the drain plug. Use a 6mm Allen wrench.
9. Drain the oil.
10. Reinstall the drain plug with a new sealing washer.
11. Torque to 14 ft-lb (19Nm).
NOTE: The sealing surfaces on the drain plug and
crankcase should be clean and free of burrs, nicks or
scratches.
12. Place towels under the oil filter.
13. Using an oil filter wrench, turn the filter counter clockwise
to remove it.
CAUTION
Hot oil may result in serious burns. Do not allow hot oil
to contact skin.
To Next Page
Loading...
Need help?
General
