5.39
Engine and Cooling Systems
5
26. Install the front torque stop assembly and torque the plate
fasteners to specification.
27. Install the air box onto the carburetor rack. Make sure to line
up the air box tabs with the air box plate.
28. Install the drive clutch. See “Drive Clutch Installation” on
page 6.20.
29. Install the driven clutch. See “Driven Clutch Installation”
on page 6.21.
30. Install the drive belt.
31. On FI models, connect he fuel filter and fuel return line by
pushing them together until you hear a audible “click”.
32. Secure the fuel return line “P” clamp onto the side of the
airbox.
33. Place the fuel filter back into the airbox-mounted holder.
34. Connect the ECU connection into the ECU.
35. Connect the EV solenoid connection to the EV solenoid.
36. Connect the coil connections to the coils.
NOTE: The WHITE connector goes to the MAG coil
(upper). The BLUE connector goes to the PTO coil
(lower).
37. Connect the regulator rectifier connections.
38. Connect intake air sensor to the air box.
= T
Front Torque Stop Fasteners: 28 ft.lb (37.9 N-m)
To Next Page
Loading...
Need help?
General
