2.8
MAINTENANCE
Maintenance References
* More often under severe use, such as operation in mud, water, sand or under severe loads.
** Every 10 hours of operation (refer to Maintenance Schedule for additional information). Change more often in extremely dirty
conditions such as continuous operation in water, mud or sand, continuous hot, cold, or short trip cold weather operation.
NOTE: Excessive clutch plate residue will accelerate oil change intervals.
*** Every 24 months or 200 hours of operation (refer to Maintenance Schedule for additional information).
More often under severe conditions such as continuous operation in water, mud or sand.
III. # Item Lube Rec. Method Frequency*
1.
Engine Oil /
Transmission
Polaris PS-4 Synthetic
Check dipstick and add to
proper level.
Perform break–in oil / filter
change at one hour; change oil
every 10hrs / 100mi. **
2. Brake Fluid
Polaris DOT 3 or DOT 4
Brake Fluid
Fill master cylinder reservoirs
to indicated level inside
reservoir.
As required. Change fluid every
2 years or 200 hours. ***
3. Drive Chain Polaris Chain Lube
Apply to chain link plates and
rollers.
As required *
1. Engine Oil and Filter
3. Rear Drive Chain
2. Brake Fluid
(Right hand and Foot
Brake Master Cylinder)
Oil Filter Location
Sight
Glass
Fill to Indicated
Level
To Next Page
Loading...
Need help?
General
