Quantum LTO-9 HH SAS User Manual

Chapter 3: Installation
Run Drive Diagnostics
Quantum LTO-9 HH SAS User’s Guide 29
characters. Each segmented character represents a test performed
during the POST. When the POST finishes, the SCD momentarily
lights all segmented characters and then goes blank.
Run Drive Diagnostics
Run the Standalone Diagnostic (see Function Code 1: Run Drive
Diagnostics on page 49).
Install Device Drivers
A device driver is firmware that enables the tape drive to interact with a
variety of servers. See Supported Device Drivers
on page 20 for
instructions on downloading the latest device drivers.
If you intend to use the tape drive with a commercial software
application, refer to that application's installation instructions to install
the device driver and configure the tape drive.
Configure the Tape Drive to a Server/Host
1 Power-on the unit.
2 To configure the tape drive, refer to the documentation for your
server/host and application software.

Quantum LTO-9 HH SAS Specifications

General

Brand	Quantum
Model	LTO-9 HH SAS
Category	Storage
Language	English