Quantum LTO-9 HH SAS User Manual

Chapter 4: Operations
Status Lights
Quantum LTO-9 HH SAS User’s Guide 35
SCD Dot If a drive dump is present while the drive is in maintenance mode, a
single dot illuminates in the lower right corner of the SCD. To copy the
dump, see Function Code 5: Copy Drive Dump
on page 52.
The SCD Dot is on solid if the dump is in RAM memory. The SCD Dot
flashes if the dump is in FLASH memory.
The SCD Dot turns off when you obtain a dump (by using IBM Tape
Diagnostic Tool (ITDT) or a SCSI command) or update the drive firmware.
Note: If the drive dump is stored in RAM memory (SCD Dot on solid),
the dump will be lost when you turn OFF the power or reset the
drive.
Status Lights
The status lights are light-emitting diodes (LEDs) that provides
information about the state of the drive. The Ready status light is green
and the Fault status light is amber, and (when lit) solid or flashing.
Mode SCD Ready LED (green) Fault LED (amber)
Operational blank On Off
Activity (tape movement) in
Operational Mode
blank Flashing Off
Maintenance solid character Flashing On
Executing Maintenance
Selection
flashing character Off On
Error Condition solid character Off Flashing
Power-On / Reset Initialization random segments Off On

Quantum LTO-9 HH SAS Specifications

General

Brand	Quantum
Model	LTO-9 HH SAS
Category	Storage
Language	English