Quantum LTO-9 HH SAS User Manual

Chapter 3: Installation
Updating firmware
30 Quantum LTO-9 HH SAS User’s Guide
Updating firmware
Caution: When updating firmware, do not power-off the drive until
the update is complete, or the firmware may be lost.
It is the customer's responsibility to ensure that this drive has the latest
firmware. Periodically check for updated levels of drive firmware by
visiting the web at http://www.quantum.com/serviceandsupport
.
Update drive firmware using:
• The host interface
• The IBM Tape Diagnostic Tool (ITDT)
• A firmware update (FUP) tape cartridge
For instructions on obtaining a new firmware image, visit http://
www.quantum.com/serviceandsupport. To update the firmware, refer to
the following sections.
Updating Firmware
through the Host
Interface
Use IBM Tape Diagnostic Tool (ITDT) to update your drive firmware.
Updating the firmware
with an FUP tape
cartridge
To update the drive's firmware from an FUP tape cartridge:
1 Create an FUP tape (see Function Code 3: Create FUP Tape on
page 51). A single FUP tape can be used to update multiple drives if
the drives are the same drive type (e.g. LTO Gen 8) and host
interface (e.g. SAS).
2 Update the drive firmware (see Function Code 2: Update Drive
Firmware from FUP Tape on page 50).
After updating the drive firmware, the FUP tape can be used as a data
cartridge by using the “Unmake FUP Tape” function (see Function Code
8: Unmake FUP Tape on page 55).

Quantum LTO-9 HH SAS Specifications

General

Brand	Quantum
Model	LTO-9 HH SAS
Category	Storage
Language	English