Quantum LTO-9 HH SAS User Manual

Chapter 4: Operations
Diagnostic and Maintenance Functions
64 Quantum LTO-9 HH SAS User’s Guide
1 Place the drive in Maintenance Mode. For instructions, see Entering
Maintenance Mode on page 47.
2 Press the Unload button once per second until either P or U appears
in the SCD. P or U will appear in the SCD to indicate the current
setting for Post Error Reporting. If you cycle past the desired code,
press the Unload button once per second until the code reappears.
3 Exit Maintenance Mode if you do not want to change the current
setting for Post Error Reporting. For instructions, see Exiting
Maintenance Mode on page 48.
4 To disable Post Error Reporting, Press and hold the Unload button
for three seconds while P appears in the SCD. The SCD changes to U
after you release the Unload Button.
5 Press the Unload button once per second to select another
Maintenance Mode Function. To exit Maintenance Mode, refer to
Exiting Maintenance Mode
on page 48.
Function Code U: Post
Error Reporting
Disabled
When Post Error Reporting is disabled, deferred-check conditions are
not reported to the host and temporary errors are not reported in the
sense data. This is the normal (default) setting for the drive. When the
drive has Post Error Reporting disabled, Function Code U will be
displayed in Maintenance Mode. The drive will default to Post Error
Reporting disabled after a reboot or power off/on cycle.
1 Place the drive in Maintenance Mode. For instructions, see Entering
Maintenance Mode on page 47.
2 Press the Unload button once per second until either P or U appears
in the SCD. P or U will appear in the SCD to indicate the current
setting for Post Error Reporting. If you cycle past the desired code,
press the Unload button once per second until the code reappears.
3 Exit Maintenance Mode if you do not want to change the current
setting for Post Error Reporting. For instructions, see Exiting
Maintenance Mode on page 48.
4 To disable Post Error Reporting, Press and hold the Unload button
for three seconds while P appears in the SCD. The SCD changes to U
after you release the Unload Button.
5 Press the Unload button once per second to select another
Maintenance Mode Function. To exit Maintenance Mode, refer to
Exiting Maintenance Mode
on page 48.

Quantum LTO-9 HH SAS Specifications

General

Brand	Quantum
Model	LTO-9 HH SAS
Category	Storage
Language	English