SAFETY
Harmony Ball Return Manual – 400-254-022 4 Rev. Date 3/16
4.3 Warnings/Symbols
READ, UNDERSTAND, and FOLLOW all of the recommended safety practices presented
in this manual before using this machine.
Only properly trained personnel should be allowed to install, adjust, or operate a
Harmony ball return.
The bowling center is a construction area during the installation of the ball return(s).
Required safety equipment, including safety glasses and safety shoes, must be worn
during installation. It is recommended that no loose clothing or jewelry be worn during
installation, operation, or maintenance.
Follow all applicable safety precautions when working around energized equipment.
Power tools such as saws, drills, nail guns, etc. present a hazard. Follow the
manufacturer’s safety recommendations when operating these products.
The ball return contains motors, belts, pulleys, and other moving parts that can present
a pinching or crushing hazard during operation. Exercise caution when working around
these components.
Do NOT remove any of the safety labels that are attached to the ball return.
DO NOT operate the ball return without all guards in place.
Do NOT have water or other liquids near the ball return during maintenance.
The following are some of the symbols that can be found on the machine and in accompanying
documentation. Be sure to observe the applicable safety warnings and precautions.
STOP, DO NOT PROCEED.
This is a warning that
hazards could exist. It is
often followed by other
symbols.
The mechanic should read,
understand, and follow the
technical manual before
servicing the machine.
LOCKOUT/TAGOUT point
for performing
maintenance.
Remove power from the
machine prior to
performing maintenance.
Eye protection is required.
An entanglement hazard
associated with belts and
pulleys exists.
Machine may start or cycle
automatically without
warning.
To Next Page
Loading...
Need help?
General
