When You Cannot Make Copies As Wanted
31
2
If You Cannot Exit from Connect Copy
This section describes about causes and remedies if you cannot exit from Con-
nect Copy.
Problem Cause Solution
There is no response
when you press [Connect
Copy].
Scanning is in progress. Press the {Clear/Stop} key on the main
machine, and then press [Stop].
There is no response
when you press [Connect
Copy].
Copying is in progress. Press the {Clear/Stop} key on the main
machine, and then press [Stop].
There is no response
when you press [Connect
Copy].
A paper misfeed has oc-
curred on either the main
machine or sub-machine.
Follow the instructions displayed.
For details, see p.105 “Removing
Jammed Paper” and p.118 “Removing
Jammed Staples”.
If the sub-machine's display indicates
that a cover is open, follow the instruc-
tions displayed.
There is no response
when you press [Connect
Copy].
A paper misfeed has oc-
curred on either the main
or sub-machine.
To cancel Connect Copy, Press the
{Clear/Stop} key on the main machine,
and then press [Stop].
There is no response
when you press [Connect
Copy].
A paper misfeed has oc-
curred on one of the ma-
chine, or toner or other
supplies need to be re-
placed.
Follow the instructions displayed.
For details, see p.87 “Loading Paper”,
p.99 “Adding Toner”, and p.105 “Re-
moving Jammed Paper”.
There is no response
when you press [Connect
Copy].
A paper misfeed has oc-
curred on one of the ma-
chine, or toner or other
supplies need to be re-
placed.
To cancel Connect Copy, press the
{Clear/Stop} key on the main machine,
and then press [Stop].
There is no response
when you press [Connect
Copy].
A paper misfeed has oc-
curred during stapling.
Removed the jammed paper.
For details, see p.118 “Removing
Jammed Staples”.
To cancel Connect Copy, press the
{Clear/Stop} key on the main machine,
and then press [Stop].
To Next Page
Loading...
Need help?
General
